Mounting Systems
Off a surface:
Leave a gap between your tiles and the surface, so you can…
Run cables behind it.
Screw threads deeper.
Use the pegboard holes with your standard pegboard accessories.
There are 8mm and 15mm off-a-surface options. 8mm is recommended.
You will need:
Single and Dual “Offset Snaps” (Double-Sided Part A)
Single Snaps, Dual Snap Connectors, and Quad Snap Connectors (Double-Sided Part B) or 10mm Mid Bolts.
Offset Pegs to support the center of tiles that are 8x8 or bigger.
Mounting Installation Tool
Off A Surface (Recommended)
On a surface:
Mount it directly onto any surface, for maximum stability and weight capacity.
You can only use short thread bolts with this setup. And you can’t use pegboard accessories.
You will need:
Regular Snaps for the corners.
Regular Dual and Quad Snap Connectors to connect tiles together.
Screw-In Fasteners to attach the snaps to the wall.
Multitool to screw in the “screw-in fasteners”.
Alternatively, forget about snaps altogether and secure the tiles by only using screws in the pegboard holes.
On A Surface
Free-standing:
Attach little legs to your Multiboard so it stands by itself, and use it as a desk organizer.
(The Multiboard is double-sided, so you can attach accessories on both sides)
You will need:
Free-Standing Feet.
Double-Sided Snap Connectors (If you’re using more than one tiles)
Tiles that don’t have pegboard holes on the bottom.
Free Standing
On a cleat:
Mount your Multiboard on a cleat to easily remove, reorganize, or transport it.
On A Cleat
You will Need:
Screw-On Cleat
Any 20 mm Big Thread, Shank Bolt
Command Strips:
Mount your Multiboard Tiles with command strips.
Command Strips
You will Need:
Snap Command Strip Mounts
Or Push-Fit Command Strip Mounts